Introduction to NUC140

•

Introduction to NUC140 and its Learning Board.

NUC140 Key Features

Core

  • Cortex™-M0 processor
  • Max frequency of 72 MHz
  • Operating voltage: 2.5V to 5.5V
  • Temperature range: - 40 ℃ ~ 105 ℃

Memory

  • 128 KB of flash memory
  • 16 KB of SRAM
  • 4 KB of Data Flash
  • ISP ( In-System Programming )
  • ICP ( In-Circuit Programming )
  • IAP ( In-Application Programming )

ADC

  • Up to 8 channels
  • 12-bit resolution
  • Up to 800 kSPS
  • A/D conversion started by PWM
  • ± 1 ℃ accurate Temperature sensor

PWM

  • Up to eight-channel PWM or three complementary paired PWM outputs
  • Period/duty trigger ADC function

Connectivity

  • Up to one SPI s ( up to 36 MHz )
  • Up to two I²C s ( up to 400 kHz )
  • Up to six UART s ( up to 1 Mbps )
  • Up to three ISO-7816-3
  • Up to two Bosch CAN 2.0A/B
  • USB 2.0 full speed
  • 16/8 bits EBI interface

Clock Control

  • 4 to 24 MHz external crystal oscillator
  • 22.1184 MHz internal RC oscillator ( ± 1 % accuracy at 25 ℃ , 5V )

Datasheet: NUC140VE3CN

NUC140 Learning Board

Trouble Shooting

  • PC USB port supply maximum current of 500mA
  • When shorted circuits or over-drive current from external electronic circuits or peripheral modules, PC may cut off the power of the USB port –> Just reboot the PC !
  • NUC140 chip is very hot when the learning board is running, the board may be damaged due to pin mis-connected to high voltage (>5V) –> Replace the learning board !!!
  • LCD has no display when it is cracked or damaged –> Replace the LCD !!!
  • LCD has no display when its soft cable on the back of the board was unplugged and did not reconnect properly –> User need to reconnect the LCD soft cable to the interface socket tightly



This site was last updated June 01, 2023.